Hello Everyone,
The HxC firmware is amazing!!!
I am so glad I found it.
I have a question that I am hoping folks can answer.
I did quite a bit of searching on the Internet, but could not find what I was looking for.
Essentially, I have an Apple IIc ROM 0 with an internal physical floppy drive.
I purchased AnotherMaker's adapter boards, wired one to go to the internal IDC20 connector and wired one up to a DB19 connector.
I followed the pinouts (and have verified that all are connected properly).
When I use the adapter board that connects directly to the IDC20 (with the internal floppy disconnected of course), it all works as it should.
If I change the adapter board to the one with the DB19 connector, the LED doesn't come on, and it does not work. I get the Check Disk Drive error.
Does anyone have any experience with trying to use this with the DB19 connector?
Could it be a ROM version problem, or could the GoTek not be receiving proper voltages?
If anyone could point me in the right direction, I would definitely appreciate it.
Thank you!!!
Frank