Use of Floppy-Emulator and Floppy-Drive switchable?

HxC Floppy Emulator E-mu Emax support
Post Reply
Hico
Posts: 2
Joined: Fri May 24, 2024 3:23 pm

Use of Floppy-Emulator and Floppy-Drive switchable?

Post by Hico »

Hello, I'm new here in the forum, but I've read a lot here in the last few weeks and got some helpful information about equipping my "new" Emax with a floppy emulator and HxC, which is also going well at the moment.

Now I have a question and I hope that someone here can help: In addition to the Gotek floppy emulator, I would also like to run a 3.5" slim floppy drive in my Emax, between which I would like to switch. So I can use the hundreds of floppies I´ve got with my Emax without converting them to HxC, but also use and expand my new build library on the floppy-emulator. I´m a little bit into electronics and soldering, but I´m not into computer things. After I looked at the shugart pin-out I wondered, if I have to make all the wires in the data line and the power supply switchablem, or would it be sufficient to just switch the "Device Select 0"-Signal (PIN 10 on the shugart drive) between the floppy-drive and the floppy-emulator and have all the other connections of both drives permanently in parallel? Maybe someone has done something like that on his/her Emax?

Best regards from germany
Heiko
Jeff
Site Admin
Posts: 8171
Joined: Fri Oct 20, 2006 12:12 am
Location: Paris
Contact:

Re: Use of Floppy-Emulator and Floppy-Drive switchable?

Post by Jeff »

yes you can redirect the DS0 signal to the drive or the floppy emulator with a simple switch.
Hico
Posts: 2
Joined: Fri May 24, 2024 3:23 pm

Re: Use of Floppy-Emulator and Floppy-Drive switchable?

Post by Hico »

Thank you, Jeff. I will try it … Regards
Post Reply