FLoppy Selector via Command Line?

HxC Floppy Emulator on IBM PC and compatible support
Post Reply
jjandersoj
Posts: 6
Joined: Wed May 16, 2018 3:23 am

FLoppy Selector via Command Line?

Post by jjandersoj »

Hi Folks,

Is there anything available to allow me to load an image file from the MS-DOS command line.

Something that I could put in a Batch File.

Along the lines of:

fileselect <Parameters> <imagefile.hfe>

I have looked around, but I'm not seeing anything.

Any comments would be welcomed.

John-A

Jeff
Site Admin
Posts: 8091
Joined: Fri Oct 20, 2006 12:12 am
Location: Paris
Contact:

Re: FLoppy Selector via Command Line?

Post by Jeff »

jjandersoj wrote:
Wed Apr 03, 2019 4:42 pm
Hi Folks,

Is there anything available to allow me to load an image file from the MS-DOS command line.

Something that I could put in a Batch File.

Along the lines of:

fileselect <Parameters> <imagefile.hfe>

I have looked around, but I'm not seeing anything.

Any comments would be welcomed.

John-A
For which emulator ?

jjandersoj
Posts: 6
Joined: Wed May 16, 2018 3:23 am

Re: FLoppy Selector via Command Line?

Post by jjandersoj »

SD HxC Floppy Emulator Rev F

Jeff
Site Admin
Posts: 8091
Joined: Fri Oct 20, 2006 12:12 am
Location: Paris
Contact:

Re: FLoppy Selector via Command Line?

Post by Jeff »

jjandersoj wrote:
Wed Apr 03, 2019 11:45 pm
SD HxC Floppy Emulator Rev F
there is the file selector for dos :

https://github.com/jfdelnero/hxcfs

this may need to be modified to support command line parameters.

jjandersoj
Posts: 6
Joined: Wed May 16, 2018 3:23 am

Re: FLoppy Selector via Command Line?

Post by jjandersoj »

Thanks Jeff. I was asking around before I went the "hard road" to see if someone had sone something like this already.

JA

Post Reply