Tune HxC emul to 2 drive mode

HxC Floppy Emulator on IBM PC and compatible support
Post Reply
algileer
Posts: 3
Joined: Wed Mar 28, 2018 10:54 pm

Tune HxC emul to 2 drive mode

Post by algileer »

I connect my HxC Emul to my pentium2

I set 8 jampers as follows:

1 ID0A OFF
2 ID1A ON
3 ID2A OFF
4 ID3A OFF
5 ID0B OFF
6 ID1B OFF
7 ID2B ON
8 ID3B OFF

I set BIOS drive a 1,44mb and drive b 1,44mb
I create HXCSDFE.CFG with 2 drives

I can not see drive select menu on HxC screen - I can select image to drive a only.
When i try read drive a - all are ok - HxC work with image
But when I try read drive b - emul red led blinks and the sound of absent disk read presents

What is wrong ? How to enable drive select menu ?
If I rewirte HXCSDFE.CFG - is it required to format sd card and write HXCSDFE.CFG first ??

Jeff
Site Admin
Posts: 8091
Joined: Fri Oct 20, 2006 12:12 am
Location: Paris
Contact:

Re: Tune HxC emul to 2 drive mode

Post by Jeff »

When one image is selected, make a long press then select the drive A or B and select the other image.

algileer
Posts: 3
Joined: Wed Mar 28, 2018 10:54 pm

Re: Tune HxC emul to 2 drive mode

Post by algileer »

Jeff wrote:
Thu Mar 29, 2018 6:04 pm
When one image is selected, make a long press then select the drive A or B and select the other image.
Thank You. I try it.

It is work.
Thanks again.

Post Reply