Gotek wont start after update

HxC Floppy Emulator on Amiga support
Post Reply
xunillo
Posts: 2
Joined: Thu Nov 04, 2021 4:54 pm

Gotek wont start after update

Post by xunillo »

Hi all,

I just bought a gotek from amigastore.eu with HxC firmware. I tried the procedure on the website to update the firmware.

The Oled was completely black during the procedure. Now after few minutes wont work.

If i reboot the gotek it doesn't show anything on the OLED. When it starts it is doing some green blink five times and stop.

I've tried to buy again the HxC bootloader and I'm trying to put f_hxc_fw_installer.upd, EXCHANGE.BIN and the last HxC firmware version (HxCFEUSB_VX_X_X_Xa.UPD. Anyway is doing the same. only 5 blink and stop. I don't know how to move forward :-(

Jeff
Site Admin
Posts: 8092
Joined: Fri Oct 20, 2006 12:12 am
Location: Paris
Contact:

Re: Gotek wont start after update

Post by Jeff »

You have an Artery Gotek, You need to use the V4.x.x.x firmware (HxCFEUSB_V4_0_5_2a.UPD present in the "WIP_Firmware")

xunillo
Posts: 2
Joined: Thu Nov 04, 2021 4:54 pm

Re: Gotek wont start after update

Post by xunillo »

Ok thank you now the firmware and OLED back to work.

I finally found the issue on the external adapter. the jumper was misconfigured. now it works! thank you for your support

Post Reply