KORG X3R

Post Reply
talmic
Posts: 2
Joined: Wed Mar 21, 2018 11:19 pm

KORG X3R

Post by talmic »

ATTENTION, pour le Korg X3R (et X3)un adaptateur 26->32 pins est obligateur. On en trouve en vente sur le Net.
La configuration est la suivante :
Avec le soft HxC Floppy Emulator, il faut utiliser : Standard 3’’5 DOS DD Floppy Disk pour la création des images.
La configuration du Gotek : S0 + MO
C’est mon 9ème synth équipé d’un Gotek, dont 7 en HxC.
Cordialement
Michel

Andrea
Posts: 2
Joined: Fri May 15, 2020 5:17 pm

Re: KORG X3R

Post by Andrea »

help with KORG X3.

I correctly installed the boot following your instructions.

I loaded last std firmware : HxCFEUSB_V3_4_15_2a.UPD in the USB stick
I choose the indexed file HXCSDFE.CFG and I put on the USB stick

I correctly flash the firmware.
I put all DSKA0000.HFE/.IMG, DSKA0001.HFE/.IMG, DSKA0002.HFE/.IMG,... in the USB stick

The unit start with 000 and count up and down correctly, BUT when I try to save a song or read something the X3 seems to start to read/write but then stop with "Drive not ready" message.


I don't have the adapter but I sold a flat 34-pin directly on the board and a real 720k floppy work fine.
Could you help me with your adapter ?
thank you

Andrea
Posts: 2
Joined: Fri May 15, 2020 5:17 pm

Re: KORG X3R

Post by Andrea »

After many tries this is the configuration that seems to work :

Jumpers : MO + SO
Firmware std

remove USB stick press both button
leave blink the 0 and as soon appear 00 increment to 11 (korg) and wait.

as soon the display is Hxc press again both button
press increment to see a 1 blinking, as soon appear 00 increments to 08 ( shugart) and wait

DONE !
It seems to work

Post Reply