Greetings,
I have limited knowledge electronically, just wanna check with the forum if this is the right way of soldering the resistor 2.2k ohm onto R12 position.
Thanks in advance.
AKAI S950 Resistor soldering
Re: AKAI S950 Resistor soldering
Btw, the connector from the sampler doesnt seem to fit SD drive's connector as well as the floppy drive.
They are both 4 pin, the grooves on both connectors dont fit well with each other.
Any thoughts?
They are both 4 pin, the grooves on both connectors dont fit well with each other.
Any thoughts?
Re: AKAI S950 Resistor soldering
This is ok, but the resistor case is a way too big.jon909 wrote:Greetings,
I have limited knowledge electronically, just wanna check with the forum if this is the right way of soldering the resistor 2.2k ohm onto R12 position.
Thanks in advance.
Here is the right form factor:
http://www.rf-microwave.com/schede/images/00000317.jpg
Re: AKAI S950 Resistor soldering
Thanks Jeff for the info re the resistor , any advise on the connectors, they both dont seem to fit each other vey well. Did i get the right SD drive for my Akai ?
Re: AKAI S950 Resistor soldering
Yes. doesn't fit at all?jon909 wrote:Thanks Jeff for the info re the resistor , any advise on the connectors, they both dont seem to fit each other vey well. Did i get the right SD drive for my Akai ?
If yes you should contact Lotharek.