Gotek Artery difficulty with bootloader install

General discussion forum - for all that doesn't fit in any other category.
Post Reply
chukroast
Posts: 4
Joined: Wed Apr 13, 2022 7:10 pm
Location: Arkansas - USA

Gotek Artery difficulty with bootloader install

Post by chukroast »

I have a gotek that was flashed with 'flash floppy', and I am trying to load the unit with the HxC firmware.

I tried using the STM32_SerialBridge with ny Gotek/Artery device, but the SerialBridge always reports a 'device error' when connecting to the gotek, even when I tried swapping the Rx/Tx connections.

Following the instructions under "ARTERY Gotek USB A to USB A cable firmware installation".....
The ArteryISPProgrammer does communicate with the unit using the USB A to A cable and I get most of the way through installing the bootloader until steps 9 & 10.
At step 10 I can find no file "hxc_fw_installer.hex" to add. I have search every unpacked zip-file with no luck, and google doesn't find it on the web.

Where can I find/get "hxc_fw_installer.hex" ??

Jeff
Site Admin
Posts: 8092
Joined: Fri Oct 20, 2006 12:12 am
Location: Paris
Contact:

Re: Gotek Artery difficulty with bootloader install

Post by Jeff »

For such support request i recommend you to contact me by email.
After the firmware registration (https://hxc2001.com/store) you should have received an email with all the needed information.

Post Reply