SOLVED: Rotary doesn't works

General discussion forum - for all that doesn't fit in any other category.
Post Reply
MartFou
Posts: 6
Joined: Mon Oct 11, 2021 11:01 pm

SOLVED: Rotary doesn't works

Post by MartFou »

Hi,
Could you say me if my connections are corrects ?
because when I turn the rotary i can't navigate trough files. I can navigate only with the Gotek native buttons.

EDIT 1: I have installed the HxCFEUSB_V4_0_5_3a.UPD
EDIT 2: The PCB card shown here https://hxc2001.com/docs/gotek-floppy-e ... -small.jpg
isn't the same as mine. The JK pin are not close the OLED connector but on the right.

Thanks for your knowledge.

Here the picture of my Gotek:
Image
Last edited by MartFou on Wed Nov 17, 2021 8:30 pm, edited 1 time in total.

Jeff
Site Admin
Posts: 8092
Joined: Fri Oct 20, 2006 12:12 am
Location: Paris
Contact:

Re: Rotary doesn't works

Post by Jeff »

Here is the rotary connections to use :
20211004_092624.jpg
20211004_092624.jpg (219.52 KiB) Viewed 1198 times

MartFou
Posts: 6
Joined: Mon Oct 11, 2021 11:01 pm

Re: Rotary doesn't works

Post by MartFou »

Thanks, it's more clear with your picture.

With you schematic when I rotate to the right the files decrease (5 to 4 to 3 to 2 to 1)
Is it possible to change that order ? from 1 to 2 to 3 to ...

MartFou
Posts: 6
Joined: Mon Oct 11, 2021 11:01 pm

SOLVED: Rotary doesn't works

Post by MartFou »

I just needed to invert the CLK and DT .

That's work well

Post Reply