Hi all,
I'm using an HxC rev C with a Camputers Lynx. I want to connect a physical 5.25" floppy drive as drive B: and have the HxC as drive A:.
The cable I have has a twist. The HxC will be connected to the header nearest the computer i.e. pre the twist.
The floppy drive will be connected to the furthest header from the computer i.e. post the twist.
I am confused about the jumper setup for the HxC, and the correct ID to jumper the physical drive as.
Can someone help please?
Thanks in advance!
Chris.
Jumper Confusion
-
- Posts: 7
- Joined: Mon Nov 30, 2015 3:01 pm
Re: Jumper Confusion
Just as an additional note I'm assuming the floppy drive being at the end of the cable will need it's terminating resistor fitted?
Re: Jumper Confusion
This is in the user manual :
In shugart systems : DS0 = ID0-X,DS1 = ID1-X,DS2 = ID2-X
X = emulator virtual drive A or B
In shugart systems : DS0 = ID0-X,DS1 = ID1-X,DS2 = ID2-X
X = emulator virtual drive A or B