HxC SD floppy emulator and DS3 on Shugart interface

[caius]

Hi all,
I'm trying to set the my HxC SD floppy emulator REV. C as drive 2 and 3 on my X68000 which has Shugart interface.It works fine as drive 2 but not it's not recognized as drive 3
Jeff, I know you have to connect pin 6 of the FDD cable to one of the jumper of your board.Can I connect the PIN6 solderside of the 34PIN header of your board to one of the ID jumper, instead.Could explain better this?

Thanks

[stevendt]

Hi Caius

I don't know whether you received an anser to your question, but if not, you may find this thread relevant . . . . .

http://torlus.com/floppy/forum/viewtopi ... =19&t=1194


Jeff, I asked this question over a year ago, at the time, I made a bodge to the floppy cable to get the HxC working with drive ID3.

I had hoped to upgrade to a Rev F HxC, but want to have the HxC jumpers correctly wired internally to support IDs 0 - 3

Can you please confirm when this mofification will be available on the hardware?
regards
Dave