Just ordered a HXC Floppy Emulator REV C cased , could someone point me to the cable I would need to hook to a TRS-80 model 4? This is a gift, so I don't have the TRS-80 in front of me (or the the HXC yet!).
Regards,
Adam
TRS-80 Model 4
Re: TRS-80 Model 4
Hi Adam,
I don't have an TRS80 Model 4. But I found this document that should help you:
http://www.retrotechnology.com/herbs_st ... Drives.pdf
Regards,
Thomas
I don't have an TRS80 Model 4. But I found this document that should help you:
http://www.retrotechnology.com/herbs_st ... Drives.pdf
Regards,
Thomas
Re: TRS-80 Model 4
A straight-through cable works fine. I.e. a 34-wire ribbon cable with a 34-pin IDC plug at one end, and a 34-pin PCB plug at the other.
https://gonk23.wordpress.com/trs-80/hxc ... -emulator/
https://gonk23.wordpress.com/trs-80/hxc ... -emulator/