I´m trying to get my new Lotharek HxC SD Floppy Emulator Rev.F to work in my Yamaha QY700 hardware sequencer:
- Firmware 1.8.2.40
- SD-Card SanDisk SDHC Class 4 32GB
- HxC Config & floppy images from "SDHxCFE_PC_1.44MB" Quick Install Disk Images
- original floppy drive EPSON SMD-1340-004-02 FF0605
The emulator is working, I can choose a floppy image ("DSKA0000.hfe"), but I am not able to safe or load anything. The files are not recognized by the QY700. I connected the emulator to the original ribbon cable which was inside the QY700.
Is there something I did wrong? Do I need a special Config setting? Wrong SD-Card? Need to change jumper settings on the emulator? Bad ribbon cable?

Help much appreciated! Greetings from Munich, Germany!

Alex