no more pins / jumpers on the new HxC

HxC Floppy Emulator E-mu SP1200 support
Post Reply
Thomas S
Posts: 2
Joined: Mon Dec 09, 2019 2:22 pm

no more pins / jumpers on the new HxC

Post by Thomas S »

Hi,

I'm ready to install a new HxC in my SP1200.

In videos found online I see where to add jumpers, but on my Hxc model the pins where jumpers had to be added are replaced by a switch.
(see attached picture)

So what are the correct settings for SP1200 on that little switch?
By default ID0A is up, while ID1A, ID2A, ID3A, ID0B, ID1B, ID2B and ID3B are down.

Sorry if this subject was covered somewhere else on the forum.
Attachments
IMG_1341.jpg
IMG_1341.jpg (148.7 KiB) Viewed 1083 times

Jeff
Site Admin
Posts: 7296
Joined: Fri Oct 20, 2006 12:12 am
Location: Paris
Contact:

Re: no more pins / jumpers on the new HxC

Post by Jeff »

ID0A up is fine for the SP1200.

Thomas S
Posts: 2
Joined: Mon Dec 09, 2019 2:22 pm

Re: no more pins / jumpers on the new HxC

Post by Thomas S »

Thank You Jeff!

Post Reply