Hi
1. I want to install GoTek USB floppy emulator for excellon CNC-6 controller
2. the firmware which comes with gotek does not meet the requirement
3. updating to HxC firmware in Gotek can be a option tried out
4. any other option suggested
Ramesh
Excellon CNC-6 controller
Re: Excellon CNC-6 controller
With the help of Jeff (Jean Francois) i successfully upgraded Gotek emulator with HxC firmware and also booted the Excellon CNC-6 controller using Pen drive and also with extended SD card. Few more small things needs to be corrected and currently in touch with Jeff to complete it. on completion of this by 100% i will update with complete instructions, photographs and videos if necessary. keep in touch
Re: Excellon CNC-6 controller
After several attempts using various parameters the Gotek USB-Floppy Emulator is successfully installed in Excellon CNC-6 controller. This emulator was enabled to this setup only after updating to HxC firmware. Thanks a lot to Jeff for his excellent support. Without his support this would not have been possible. Thanks Jeff.
Will update with step by step procedure soon about this setup. in the mean time sharing the success video, see the link below
https://www.youtube.com/watch?v=j-BU9R4sJds
Will update with step by step procedure soon about this setup. in the mean time sharing the success video, see the link below
https://www.youtube.com/watch?v=j-BU9R4sJds
-
- Posts: 2
- Joined: Thu Mar 02, 2017 8:08 am
Re: Excellon CNC-6 controller
Thanks for uploading this video link i have watched it and it really clears my understanding. Thanks Ramesh
Re: Excellon CNC-6 controller
you are welcome John, nice to hear that you are able to understand