Someone could tell me what the cable layout to install a slim HXC SD 6128 internally.
This means pass from the 26-pin connector to the controller 34 of the HXC.
I followed the instructions cpcwiki page, but it does not work. It can't read the SD content.
Imagen del CPCWIKI
![Image](http://retrohobby.es/I1/10.jpg)
Mi cable
![Image](http://retrohobby.es/I1/1.jpg)
![Image](http://retrohobby.es/I1/2.jpg)
![Image](http://retrohobby.es/I1/3.jpg)
The SD is formatted in FAT32 and after the HXCSDFE.CFG, AUTOBOOT.hfe
![Image](http://retrohobby.es/I1/4.jpg)
The pin is placed at position 1 ON
![Image](http://retrohobby.es/I1/5.jpg)
Then I found this picture in another forum thread.
http://torlus.com/floppy/forum/viewtopic.php?f=8&t=259
![Image](https://hxc2001.com/floppy_drive_emulator/cpc6128floppytopcfloppy.gif)
I made a mess.
I uploaded a video to youtube of what happens.
http://www.youtube.com/watch?v=5hri4Wnn ... load_owner
I would appreciate any help.