How do I connect this to a PC?

HxC Floppy Emulator on IBM PC and compatible support
Post Reply
workingclasshacker
Posts: 1
Joined: Sun Aug 12, 2018 12:26 am

How do I connect this to a PC?

Post by workingclasshacker » Sun Aug 12, 2018 10:49 pm

Hi, I got a HxC from lotharek and it looks great! However, my PC floppy cable has one pin "filled in" making none of the ends possible to connect to the ribbon cable connection on the circuit board. How do I connect it? Are there like adapters or something I should use? If not, how do I match the pinout of the HxC to the "missing pin" layout of the ribbon cable?

Regards,
WorkingClassHacker

Jeff
Site Admin
Posts: 6649
Joined: Fri Oct 20, 2006 12:12 am
Location: Paris
Contact:

Re: How do I connect this to a PC?

Post by Jeff » Mon Aug 13, 2018 12:49 am

workingclasshacker wrote:
Sun Aug 12, 2018 10:49 pm
Hi, I got a HxC from lotharek and it looks great! However, my PC floppy cable has one pin "filled in" making none of the ends possible to connect to the ribbon cable connection on the circuit board. How do I connect it? Are there like adapters or something I should use? If not, how do I match the pinout of the HxC to the "missing pin" layout of the ribbon cable?

Regards,
WorkingClassHacker
this pin is not used/not connected.

so you can :

- use another floppy ribbon
or
- make a small hole into the floppy ribbon to make the connection possible

Post Reply