Auto boot problem

[Beaps]

Hi,

I have an Amiga 600 & when I run the autoboot file the HxC program loads but nothing else happens.

It does not read the drive?

It says just the press Help button etc

Any Ideas?

[Beaps]

Any one help me out?

[Jeff]

NTSC Amiga ?

HxC on DF1 ?

Jumper config ?

Floppy Cable used ?

HxC Firmware used ?

Kickstart Version ?

[Beaps]

NTSC Amiga ? Pal

HxC on DF1 ? HxC DF0

Jumper config ? bottom right

Floppy Cable used ? original Amiga one

HxC Firmware used ? Not been updated in last 8 months

Kickstart Version ? 2.1

[Beaps]

I'm also using a micro SD 8gb in a SD caddy if that helps?

[Jeff]

Can you take a screenshot ?

[Beaps]

Sure, even better I will do a quick video.

[Beaps]

here you go...

I hope you can help me out

http://www.youtube.com/watch?v=iiXroCvzA4k&feature=plcp

Just a thought, do the files have to be in a folder on the SD card or in the route?

[Jeff]

here you go...

I hope you can help me out

http://www.youtube.com/watch?v=iiXroCvzA4k&feature=plcp

Just a thought, do the files have to be in a folder on the SD card or in the route?

Ok i see : your jumper setting is complety wrong :

Page 9 : https://hxc2001.com/floppy_drive_emulat ... Manual.pdf
Use the ID0-Drive A setting.

[Beaps]

simple as that, changed the jumper, jobs a good one

THANKS!!!

[Jeff]

simple as that, changed the jumper, jobs a good one

THANKS!!!

Don't forget to update the youtube video

[Beaps]

hahaha will do THANKS!