Amiga 600HD wont see SD CL - HXC Floppy Emulator REV C

HxC Floppy Emulator on Amiga support
Post Reply
Torgo
Posts: 6
Joined: Sun May 07, 2017 12:37 am

Amiga 600HD wont see SD CL - HXC Floppy Emulator REV C

Post by Torgo » Sun May 07, 2017 12:52 am

Update...

Uses the hold the mouse buttons down to power up the 600HD and disabled the hd boot.
Booting from DF0: gives me "NOT A DOS DISK" error.

I have used the same SD card on the Atari ST and no problem
reformatted it again, installed software again.. still same problem.
If i boot without the SD card its reports that the floppy is missing.

What am i missing?



Thought it might be the ribbon cable. Not the problem.
Amiga 600hd boots to workbench sees drive but has ???? for name.
Can not open dir. Device powers up. Can manually via buttons enter files into slots.
But they wont boot.. always boots to the HD.
I have one for my 1040ST and it works flawless

Help please..

Torgo
Posts: 6
Joined: Sun May 07, 2017 12:37 am

Re: Amiga 600HD wont see SD CL - HXC Floppy Emulator REV C

Post by Torgo » Mon May 08, 2017 1:20 am

Additional info.. played with the jumper settings... nothing changed.
tried single drive jumper.. nothing..
even tried to flip the ribbon cable upside down (shaving off the position tab on the cable).. didn't see the drive at all.


Argh.....

Torgo
Posts: 6
Joined: Sun May 07, 2017 12:37 am

Re: Amiga 600HD wont see SD CL - HXC Floppy Emulator REV C

Post by Torgo » Thu May 18, 2017 4:29 am

Turns out it was the ribbon cable that I purchased along with the HXC... hmmmm

Post Reply