Gotek on a Brother BAS-342E

Post Reply
Drack502
Posts: 1
Joined: Tue May 02, 2017 4:18 pm

Gotek on a Brother BAS-342E

Post by Drack502 » Tue May 02, 2017 4:24 pm

I have install a Gotek emulator on a Brother BAS-342E and it will read the programs off of the USB but in order to select a different program on a different virtual disk I have to turn the machine off than back on, select the disk, then select the program on the Brother.

Example: I can select disk000 then select program #1, it will load and work fine. Then if I select disk001 then select program #1, program #1 from disk000 will still be in memory and that is the one that be loaded.

Any thought? Maybe something to do with the jumpers?

Thanks.

mondo1976
Posts: 141
Joined: Mon Dec 28, 2015 3:54 pm

Re: Gotek on a Brother BAS-342E

Post by mondo1976 » Tue May 02, 2017 10:59 pm

Not the jumpers, but rather the Interface type. I'm pretty sure it's a problem with the disk change signal, so you need to try a different profile or two until you find one that has the correct signal on pin 2. Or similarly it might be confused by the ready signal. Either way, you should eventually stumble upon the right choice if you just sequentially make your way down the list.

Post Reply