I got a GOTEK SFRC922 from some seller in ebay.com to connect it to a FANUC CNC Machine. By default I am able to read the first 1.44 MB virtual floppy disk. But the problem to read the second floppy we have to restart the device (if connected to CNC then restart the CNC machine itself) and switch to the second virtual floppy and read from there.
First Question?
Has anyone been in a situation similar to this and resolved? If so what was the solution.?
Second Question?
By Upgrading to a HxC Firmware will my GoTek Device perform normally as required above (i.e. without a restart)?
GoTek Issues with FANUC CNC machines.
Re: GoTek Issues with FANUC CNC machines.
yes probably.ppdeec wrote: Second Question?
By Upgrading to a HxC Firmware will my GoTek Device perform normally as required above (i.e. without a restart)?
Re: GoTek Issues with FANUC CNC machines.
Hi Jeff,
Even though you have said probably, I would like to go ahead and update the new firmware on the device. I have sent an email on ----------. Please give me the details.
Even though you have said probably, I would like to go ahead and update the new firmware on the device. I have sent an email on ----------. Please give me the details.