hello,
i was trying to inject the firmware hxc into my gotek SFRC922C but i can't.
First i not sure at all of the soldering point i have to soldon the GOTEK
i have 7 point i think in this 7 point there is: RX TX GND 5V and some others but i not sure of the 'name' point.
on my usb uart i have solder gnd 5 v rx and tx.
i has follow some tutorial and try but the hxc never detect my gotek.
if some have the process for the gotek SFRC922C it will be very nice to help me.
thank you
gotek sfrc922c soldering point for injecting firmware
Re: gotek sfrc922c soldering point for injecting firmware
please post a picture of your connections.
Re: gotek sfrc922c soldering point for injecting firmware
I am having the same issue with the revC board. The pinout is different than the revB board. It appears the 5V pin and GND have been switched. Best to power the board from the standard power in connection to avoid a blown voltage regulator (like mine). I'm tracing the pins down and will post if others haven't already