MPC60II gotek/HxC settings and configuration

HxC Floppy Emulator Akai Keyboards/Samplers support
Post Reply
Silverfish
Posts: 2
Joined: Tue Oct 10, 2017 8:03 am

MPC60II gotek/HxC settings and configuration

Post by Silverfish » Tue Oct 10, 2017 8:12 am

Hi all,

I recently installed the HxC bootloader onto an older 2-digit Gotek (model SFRM72-TU100K), but I can't seem to get the MPC60II to recognize anything that's happening on the drive. When I power up the MPC, the drive shows "hc", then allows me to select a disk image via the two buttons. However, the MPC says there is no disk in the drive, error code FF80.

Which direction should the data cable go? What are the correct jumper settings? Am I using the wrong firmware? Could it be the config file?

Thanks so much for your help!

Jeff
Site Admin
Posts: 4852
Joined: Fri Oct 20, 2006 12:12 am
Location: Paris
Contact:

Re: MPC60II gotek/HxC settings and configuration

Post by Jeff » Tue Oct 10, 2017 11:44 am

The jumper must be on S0.
If the green led is always on, try to reverse the floppy ribbon.

Silverfish
Posts: 2
Joined: Tue Oct 10, 2017 8:03 am

Re: MPC60II gotek/HxC settings and configuration

Post by Silverfish » Wed Oct 11, 2017 6:35 am

Funny. I could have sworn I tried this particular configuration, but apparently not.

It's working fine now. Thank you for your help!

Post Reply