MSX2 External Floppy Drive Cable Advice

HxC Floppy Emulator on MSX and compatible support
Post Reply
StarshipUK
Posts: 10
Joined: Sat Aug 28, 2010 12:33 pm

MSX2 External Floppy Drive Cable Advice

Post by StarshipUK » Fri Aug 05, 2011 11:35 pm

I have a MSX 2 (Phillips VG-8235) and would like to use a HXC Floppy Drive Emulator SD with it.

But noticed on the main page it says:
Warning : The MSX2 computers often used a non-standard floppy connector pinout.
Before plugging the HxC Floppy Emulator please check that the pinout is compatible.

Is it possible to use the HXC Floppy Emulator with the MSX2 External Floppy Port, and do I need a specially wired cable for this?

Also I am quite new to the MSX2 and have not had mine long. What command would I need to type to access and load disks using the HXC Floppy Emulator connected to the External Floppy Port?

Any help is really appreciated.

mau_rizio
Posts: 69
Joined: Tue May 05, 2009 5:08 pm

Re: MSX2 External Floppy Drive Cable Advice

Post by mau_rizio » Sat Aug 06, 2011 12:58 am

If i remember correctly it's a standard 34 pin cable and the drive is the B unit.
From basic you can use FILES "B:" to list the content of the disk.
But the 8235 can read only 360k floppy.

I'm on holyday so i can't test it, i will be back in 2 weeks.

bye
mau

Post Reply