HXC and PSUs

[cpcspain]

Hello, I'm testing my new HXC SD FLoppy emulator. Congratulations, it's a cool device.

My CPC 6128 had never seen so much software !

I don't know why the HXC board only works with my Amiga 4000 PSU. If I connect an AT psu, or I get the +5v from my CPC monitor, the device works, I can browse the SD with the HXC buttons but when type |b in cpc, I see this error:

Floppy missing, retry or cancel?

OK, perhaps my CPC monitor gives only 2A for the CPC and it's not enough for the HXC , but I don't understand why don't work with the AT psu.

What kind of psu's are you using ?

Thank you

[Jeff]

Hello, I'm testing my new HXC SD FLoppy emulator. Congratulations, it's a cool device.

My CPC 6128 had never seen so much software !

I don't know why the HXC board only works with my Amiga 4000 PSU. If I connect an AT psu, or I get the +5v from my CPC monitor, the device works, I can browse the SD with the HXC buttons but when type |b in cpc, I see this error:

Floppy missing, retry or cancel?

OK, perhaps my CPC monitor gives only 2A for the CPC and it's not enough for the HXC , but I don't understand why don't work with the AT psu.

What kind of psu's are you using ?

Thank you

This is probably not a psu problem.

Did you follow the user manual to connect the Floppy Emulator to your CPC ? :
https://hxc2001.com/floppy_drive_emulat ... Manual.pdf (page 4 & 9)

[cpcspain]

Hi Jeff,

After clean the disk drive connector, now I'ts working well.

I'm getting the 5v from the CPC.

Thanks!