SD HxC Rev C- Gerber Board Outline

General discussion forum - for all that doesn't fit in any other category.
Post Reply
TRSguy
Posts: 2
Joined: Wed Jun 20, 2018 6:00 pm

SD HxC Rev C- Gerber Board Outline

Post by TRSguy » Wed Jun 20, 2018 6:13 pm

I am trying to get a couple SD HxC Rev C boards made for my TRS80s and noticed that there does not appear to be a "board outline" gerber file in the listing of gerber files. This is required for the online board houses I was looking at. This seems to be a pretty simple file and I was wondering if someone has or can direct me to a file I can use as the board outline?

Thanks!

Jeff
Site Admin
Posts: 5753
Joined: Fri Oct 20, 2006 12:12 am
Location: Paris
Contact:

Re: SD HxC Rev C- Gerber Board Outline

Post by Jeff » Fri Jun 22, 2018 7:24 am

TRSguy wrote:
Wed Jun 20, 2018 6:13 pm
I am trying to get a couple SD HxC Rev C boards made for my TRS80s and noticed that there does not appear to be a "board outline" gerber file in the listing of gerber files. This is required for the online board houses I was looking at. This seems to be a pretty simple file and I was wondering if someone has or can direct me to a file I can use as the board outline?

Thanks!
will check but i think it is included.

TRSguy
Posts: 2
Joined: Wed Jun 20, 2018 6:00 pm

Re: SD HxC Rev C- Gerber Board Outline

Post by TRSguy » Fri Jun 22, 2018 8:17 pm

After double checking I found that the DRD file has a an outline as well as drill information.

Post Reply