Eagle files
Eagle files
Hi Jeff, is there any eagle files for the SDCARD HxC Floppy Emulator that you can upload? or is there somebody else how have done some eagle file. i like the original layout, simpel and right size.
Re: Eagle files
No eagle file since i don't use eagle. It's a LAYOUT based pcb (Cadence - Orcad)Azzrael wrote:Hi Jeff, is there any eagle files for the SDCARD HxC Floppy Emulator that you can upload? or is there somebody else how have done some eagle file. i like the original layout, simpel and right size.
Re: Eagle files
I made a PCB from a very slightly changed design made by Pryanick using Eagle (*.brd file).Azzrael wrote:Hi Jeff, is there any eagle files for the SDCARD HxC Floppy Emulator that you can upload? or is there somebody else how have done some eagle file. i like the original layout, simpel and right size.
If I get Jeff's permission I can send you the Eagle files as well as the layout diagram. The only change compared to the original prototype is a changed power section (can be directly connected to floppy power cable, no special power adapter needed). It is 100% software compatible with the original prototype.
Sven
Non-Eagle version
I was making an unrelated prototype board and since the incremental cost for merging a second area to the same board was virtually zero I did a quick and dirty prototype of the Jeff's *new* design - a single TTL chip. Not much attempt made at miniaturization but the board is about 1/2 the size of the original single-layer board.
It won't be hard to fit ALL the electronics under the LCD screen so that the whole board could fit into a 3.5" floppy opening in a standard PC style case.
Anyway since Jeff promised a software update to match the changed design I'll wait for that rather than trying to modify the old one.
I'll be happy to share the Gerbers and/or the design file. I use Altium Designer, not Eagle.
http://alexfreed.com/FPGApple/SD_disk.jpg
It won't be hard to fit ALL the electronics under the LCD screen so that the whole board could fit into a 3.5" floppy opening in a standard PC style case.
Anyway since Jeff promised a software update to match the changed design I'll wait for that rather than trying to modify the old one.
I'll be happy to share the Gerbers and/or the design file. I use Altium Designer, not Eagle.
http://alexfreed.com/FPGApple/SD_disk.jpg
-Alex.
Sorry there are no firmware for this. please wait the official version.petersieg wrote:@alexfreed: Hey, looks great!
Could you please send me your design files incl. gerber and the firmware you used.. probably a zip archive to: peter.sieg1 (at) gmx.de
Thanks!
Peter
(i don't support third party pcb... thanks for your understanding...)