HELP! SecSerialBridge software - ends with an error.

General discussion forum - for all that doesn't fit in any other category.
ncbelov
Posts: 13
Joined: Thu Feb 06, 2020 12:43 am

Re: HELP! SecSerialBridge software - ends with an error.

Post by ncbelov » Tue Feb 11, 2020 11:02 pm

The issue was resolved. The problem was that after PIC18 firmware at 1 power on, wait for the LED to blink.
I did not make a problem from here. This is not written anywhere.

Jeff
Site Admin
Posts: 6987
Joined: Fri Oct 20, 2006 12:12 am
Location: Paris
Contact:

Re: HELP! SecSerialBridge software - ends with an error.

Post by Jeff » Wed Feb 12, 2020 8:28 am

ncbelov wrote:
Tue Feb 11, 2020 11:02 pm
The issue was resolved. The problem was that after PIC18 firmware at 1 power on, wait for the LED to blink.
I did not make a problem from here. This is not written anywhere.
Yes apparently i forgot to mention this point... :oops:
Fine if this is working fine now.

Post Reply