Hi all,
I'm trying to set the my HxC SD floppy emulator REV. C as drive 2 and 3 on my X68000 which has Shugart interface.It works fine as drive 2 but not it's not recognized as drive 3
Jeff, I know you have to connect pin 6 of the FDD cable to one of the jumper of your board.Can I connect the PIN6 solderside of the 34PIN header of your board to one of the ID jumper, instead.Could explain better this?
Thanks
HxC SD floppy emulator and DS3 on Shugart interface
Re: HxC SD floppy emulator and DS3 on Shugart interface
Hi Caius
I don't know whether you received an anser to your question, but if not, you may find this thread relevant . . . . .
http://torlus.com/floppy/forum/viewtopi ... =19&t=1194
Jeff, I asked this question over a year ago, at the time, I made a bodge to the floppy cable to get the HxC working with drive ID3.
I had hoped to upgrade to a Rev F HxC, but want to have the HxC jumpers correctly wired internally to support IDs 0 - 3
Can you please confirm when this mofification will be available on the hardware?
regards
Dave
I don't know whether you received an anser to your question, but if not, you may find this thread relevant . . . . .
http://torlus.com/floppy/forum/viewtopi ... =19&t=1194
Jeff, I asked this question over a year ago, at the time, I made a bodge to the floppy cable to get the HxC working with drive ID3.
I had hoped to upgrade to a Rev F HxC, but want to have the HxC jumpers correctly wired internally to support IDs 0 - 3
Can you please confirm when this mofification will be available on the hardware?
regards
Dave