We are tryin' to install HXC into WTB so far we managed to connect it and we have problem with DRIVE NOT READY message.
Looks like there is an issue with configuration of PIN 34.
When is set to signal ready system freeze, when set to HIGH seems to work (system don't freeze) but drive is still not ready.
inside PPG WT-B are YD-380 drives.
HELP.. we would like to make PPG WTB finally work with HXC.
thanx in advance
Damir
PPG Waveterm B with HXC.. help needed
Re: PPG Waveterm B with HXC.. help needed
- Old Drive : What is the old drive brand a model ? (a picture please).
- Old Drive : What is old drive jumper setting ? (a picture please).
- HxC Drive : Which file(s) image used ?
- HxC Drive : Which cfg file used ?
- HxC Drive : Which jumper/switch setting used ?
- HxC Drive : If you have an HxC with an LCD screen please make a picture of the screen with an file image selected.
- HxC Drive : How did you connected the HxC ? (a picture please).
- Old Drive : What is old drive jumper setting ? (a picture please).
- HxC Drive : Which file(s) image used ?
- HxC Drive : Which cfg file used ?
- HxC Drive : Which jumper/switch setting used ?
- HxC Drive : If you have an HxC with an LCD screen please make a picture of the screen with an file image selected.
- HxC Drive : How did you connected the HxC ? (a picture please).
Re: PPG Waveterm B with HXC.. help needed
Hi guys,
any News on this Topic?
we have to find a solution - original drives will all die ...
any News on this Topic?
we have to find a solution - original drives will all die ...
Re: PPG Waveterm B with HXC.. help needed
Jeff wrote:- Old Drive : What is the old drive brand a model ? (a picture please).
- Old Drive : What is old drive jumper setting ? (a picture please).
- HxC Drive : Which file(s) image used ?
- HxC Drive : Which cfg file used ?
- HxC Drive : Which jumper/switch setting used ?
- HxC Drive : If you have an HxC with an LCD screen please make a picture of the screen with an file image selected.
- HxC Drive : How did you connected the HxC ? (a picture please).