Hello there,
I've had my engineer install a Rev F black into my Kurzweil K2500r.
Following instructions, I've formatted the SD card in ms dos, placed the hxcsdfe.cfg file on the card and created a 1.44 meg disk image.
I am thus now able to read my newly created image on the sampler... However, when trying to format the image I'm given a 'disk is write protected' message.
Any pointers on what I may have missed?
Kurzweil K2500r
Re: Kurzweil K2500r
Where did you take the files ?
Try to update the firmware :
https://hxc2001.com/download/floppy_driv ... rmware.zip
Try to update the firmware :
https://hxc2001.com/download/floppy_driv ... rmware.zip
Re: Kurzweil K2500r
thanks for your prompt reply jeff
i downloaded the firmware from here :
https://hxc2001.com/floppy_drive_emulat ... rmware.zip
i’ve run the update but still no joy
i downloaded the firmware from here :
https://hxc2001.com/floppy_drive_emulat ... rmware.zip
i’ve run the update but still no joy
Re: Kurzweil K2500r
And what about the disk images used ? Did you take an ready-to-use 1.44MB DOS images ? :
https://hxc2001.com/download/floppy_driv ... Images.zip
What is the old disk drive model and brand, and how the it's jumper are ?
https://hxc2001.com/download/floppy_driv ... Images.zip
What is the old disk drive model and brand, and how the it's jumper are ?
Re: Kurzweil K2500r
yes i had taken a ready to use dos image…. but have tried again from this link
the old disk drive is a : sony mpg 5201
it has three pins and (from left to right) pins 2 & 3 are connected
the old disk drive is a : sony mpg 5201
it has three pins and (from left to right) pins 2 & 3 are connected
Re: Kurzweil K2500r
Please send me the HFE files and a pictures of the old disk drive by email :
https://hxc2001.com/contactus/
https://hxc2001.com/contactus/
Re: Kurzweil K2500r
Hi Jeff,
Did you receive my mail?
Did you receive my mail?
Re: Kurzweil K2500r
i'm really sorry for the late reply
just had my engineer round... it appears the jumpers were set incorrectly, the 1st three are now on and the rest are off. the drive works flawlessly.
thank you for your assistance
just had my engineer round... it appears the jumpers were set incorrectly, the 1st three are now on and the rest are off. the drive works flawlessly.
thank you for your assistance