Yamaha QX-3 midi hardware sequencer floppy disk conversions

HxC Floppy emulator support for all others Keyboards/Samplers...
Mink99
Posts: 9
Joined: Mon Oct 14, 2013 1:52 am

Re: Yamaha QX-3 midi hardware sequencer floppy disk conversi

Post by Mink99 » Tue Jun 06, 2017 11:23 pm

So i checked all permutations,

the cable works with the provided floppy, but not with the Lotharek, so it must be either the ready signal, or another command
that the qx3 issues to start a read sequence. This signal is never acknowledged by the Lotharek.

this could be diskc,mton or sth else.

the device is connected by a non twisted cable, pin 1 of the fdc connected to pin one of the Lotharek.

i am about to give up....

Mink99
Posts: 9
Joined: Mon Oct 14, 2013 1:52 am

Re: Yamaha QX-3 midi hardware sequencer floppy disk conversions

Post by Mink99 » Thu Oct 12, 2017 12:12 am

Anyone ?

Jeff
Site Admin
Posts: 4985
Joined: Fri Oct 20, 2006 12:12 am
Location: Paris
Contact:

Re: Yamaha QX-3 midi hardware sequencer floppy disk conversions

Post by Jeff » Thu Oct 12, 2017 12:44 pm

Mink99 wrote:
Thu Oct 12, 2017 12:12 am
Anyone ?

already answered six months ago : Disk change detection not working -> Bad interface mode, or floppy ribbon wire n°2 broken.
And now i add : bad jumper setting (should be ID0-A+ID3-B here + use my cfg file present on this thread: http://torlus.com/floppy/forum/viewtopi ... 311#p11796) and/or wrong floppy ribbon connection (wrong way like this case : http://torlus.com/floppy/forum/viewtopi ... =28&t=3218).
If you are 100% sure about your connections and jumper settings, enter the embedded hxc menu to clear the eprom and try other pin 02 & pin 34 settings.

Post Reply