How do I save?

HxC Floppy Emulator E-mu Emulator I & II support
Post Reply
Egg
Posts: 8
Joined: Tue Nov 08, 2011 7:13 pm

How do I save?

Post by Egg » Sat Aug 30, 2014 7:29 pm

As subject how do you save banks etc to HxC? The empty disk images (and the ram test image) supplied in the SDHxCFE_Emu_Emulator_II folder, produce an overlay error. I normally use 3.1 OS.

Jeff
Site Admin
Posts: 6463
Joined: Fri Oct 20, 2006 12:12 am
Location: Paris
Contact:

Re: How do I save?

Post by Jeff » Sun Aug 31, 2014 8:24 am

Egg wrote:As subject how do you save banks etc to HxC? The empty disk images (and the ram test image) supplied in the SDHxCFE_Emu_Emulator_II folder, produce an overlay error. I normally use 3.1 OS.
No particular action should be needed.
What do you mean by "overlay error" ?

Have you checked the switch setting, the floppy ribbon?

Which HxC version have you (Hw & Sw) ?

Egg
Posts: 8
Joined: Tue Nov 08, 2011 7:13 pm

Re: How do I save?

Post by Egg » Wed Sep 03, 2014 12:37 am

Hi Jeff, I have a Rev C sd card version. I installed it 3 years ago. It worked fine but I never tried to save to it. I just decided to update the firmware to the latest one and have a go at saving a bank.

Basically I loaded a bank from the SD card (A OMI bank) then selected one of the blank supplied templates. As soon as I select any of the blank templates, the EII displays "overlay error".

I discovered the only way I can save is by selecting an existing sample bank from my collection and saving over it.

Jeff
Site Admin
Posts: 6463
Joined: Fri Oct 20, 2006 12:12 am
Location: Paris
Contact:

Re: How do I save?

Post by Jeff » Sat Sep 06, 2014 10:33 pm

are sure that this is a rev C ? can you post a picture of the board?

Egg
Posts: 8
Joined: Tue Nov 08, 2011 7:13 pm

Re: How do I save?

Post by Egg » Thu Sep 25, 2014 11:43 am

Image

Jeff
Site Admin
Posts: 6463
Joined: Fri Oct 20, 2006 12:12 am
Location: Paris
Contact:

Re: How do I save?

Post by Jeff » Sat Sep 27, 2014 8:14 am

Egg wrote: Basically I loaded a bank from the SD card (A OMI bank) then selected one of the blank supplied templates. As soon as I select any of the blank templates, the EII displays "overlay error".
can you share this image ?
Egg wrote: I discovered the only way I can save is by selecting an existing sample bank from my collection and saving over it.

So finally you can save something on these images ?

Post Reply