Hello everyone. I've been searching a while on the forum and found some topics about this but didn't get to fix my problem yet:
Everything works as expected when I convert and write files to the SD card with the computer.
Everything works when I load that SD card bank onto the Emax with the HxC drive.
Problems when I try to Save the bank, even saving the very same bank without changes:
---- The HxC display shows: RA T:73/80 while a short buzz tone sounds, then RA/WA (x2) , then RA T:18/80. and "DISK ERROR" in the Emax screen.
If I try to load that very same bank after it, I get the same RA T:18/80 message stuck in the display and a DISK ERROR message on the Emax. Nothing happens.
Details:
gear: Emu Emax 1 (basic 1000 model, nor SE neither HD, plus, etc..). OS 3.2
HxC SD Floppy Emulator: Brand new, firmware updated to 1.8.6.15a (older was 1.8.4?, same problem)
Bank I am currently using: Original Emu ZD bank, it loads up to T:73/80 on startup. Checked different banks, same result.
SD cards: Kingston 16 Gb /SD HC I. 90Mb/s Read ///45 Mb/s Write. Also checked an old SD with no label, 256 Mb.
Any suggestion? Thanks in advance
DXF
Save Error (FIXED)
Save Error (FIXED)
Last edited by DXF on Thu Mar 03, 2016 12:37 am, edited 1 time in total.
Re: Save Error (FIXED)
Update: FIXED.
I was able to save the bank changing the settings in the CFG config file.
In the Floppy Emulator Settings, I had to select "Generic Shugart" instead EMU "Shugart" in HFE File Interfacemode.
Also selected "Generic Shugart" in the SD HxC Floppy Emulator Interface Setting.
Hope it helps.
DXF
I was able to save the bank changing the settings in the CFG config file.
In the Floppy Emulator Settings, I had to select "Generic Shugart" instead EMU "Shugart" in HFE File Interfacemode.
Also selected "Generic Shugart" in the SD HxC Floppy Emulator Interface Setting.
Hope it helps.
DXF